designed for short-circuited to power PNP sensors, it is possible only with the help of special npn-to-pnp converter, otherwise, both the sensor and the controller may be damaged. Connection to controllers with PNP inputs, i.e. Reversing the polarity when power will damage the sensor.Ģ. The key is recommended to hold for a short lever, so as not to develop excessive force when screwing. For adjustment, a 2mm hex key is used from the kit, both screwing in and loosening of the adjustment screws located inside the holes, closed with elastic bands. The results of the indicator must have to the same values in these three selected points. The indicator is set in the spindle (you will need to moving the spindle in XY coordinates), the stylus of the indicator is located to measure the deviations in height. The indicator should be sensitive to a weak effect of 0.3-0.5N (for example, most lever indicators have this property).įor adjustment, three points are selected at the measuring pad (shown with red crosses) approximately at the edge of the site in the direction of the adjustment holes. As a result of the adjustment, the surface of the measuring platform should become parallel to the XY plane. Three threaded holes are prefabricated in the machine body:īefore starting the measurement, it is necessary to adjust the device. The device is fixed to the machine body with three M3 screws. Placement Vesr TSm is recommended to be chosen so that the entire surface of the ceramic platform of the device is in the working area of the machine, with an indent from the boundaries = the maximum diameter of the tool being measured + 2mm. Permitted deviation of the measuring pad in XYZ directions The device can be used with various CNC systems: LinuxCNC, Mach3, embedded systems on industrial machines, etc. CNC milling machine generates coordinates when the tool touchs the VersTSm measurement pad and uses them to calculate the height and diameter of the tool. The Vers TSm sensor is used to determine tool height and diameter.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |